Starting Up the Set-Top Box
Switching Off the Set-Top Box – Standby Mode
A
Hold down the button for approx. two seconds to switch off the set-top box
after use.
The current programme is terminated and the set-top box switches to
standby mode. Your set-top box remains on standby in standby mode; the
power LED (green) lights up. Picture and sound are no longer forwarded to
the connected devices.
The following applies in standby mode:
u
Current recordings continue to be executed.
u
Programmed recordings will be started on time.
u
EPG updates will be performed occasionally.
Alternative operation on the set-top box:
y
Use the standby button to switch the set-top box to standby mode.
Note: The sleep function allows you to switch the set-top box automatically to standby
mode after a definable period of time.
Disconnecting the Set-Top Box from the Mains
If you want to disconnect your set-top box from the mains using the deviceswitch on
the rear of the housing, you should do so in the sequence below in order to protect the
internal hard disk:
1. If the set-top box is still active, switch it to standby mode (see "Switching Off the Set-
Top Box – Standby Mode" on page 20).
2. Set the device switch to position 0.
The set-top box is disconnected from the mains. The display is now blank.
Caution: If you switch off the set-top box with the device switch, current recordings will
be aborted and programmed recordings will not be executed. Programmed timers will
be deleted.
20