Holding A Single Call - Hitachi SelecSet 400A User Manual

C 1: A
HAPTER BOUT

Holding a Single Call

Using a hold
loop
Holding a call
using hold
loops
Holding a call
using the
HOLD key
HCXTD830, Rev. A01, July 2001
Y S S 400A
OUR ELEC ET
If your console is programmed with hold loops, this is the
preferred way to hold a single call because hold loops do
not tie up CAPs.
Follow these steps to place a call on hold using hold loops.
1
Press a hold loop (HLD1–HLD8) while talking on an
active call. The hold loop winks representing the held
call.
2
Press the winking hold loop to retrieve the call.
Follow these steps to place a call on hold using the
<HOLD> key:
1
Press the <HOLD> key while talking on an active
call. A CAP winks representing the held call.
2
Press the winking CAP to retrieve the call.
Note: While hold loops are preferred for single calls,
you can only hold a conference using the
<HOLD> key. See
Conference"
H
OLDING A
"Creating a Three-party
on page 1-40.
S C
INGLE ALL
1-33