Dell PowerConnect W-Airwave Configuration Manual page 128

Table 48 Aruba Configuration > Profiles > EDCA AP Profile Settings (Continued)
Field
Encryption
WEP Transmit
Key Index
WEP Key 1
WEP Key 2
WEP Key 3
WEP Key 4
WPA Hexkey
WPA
Passphrase
Other Settings
DTIM Interval
(1-255 beacon
periods)
Station Ageout
Time
802.11g
Transmit
Rates
802.11g Basic
Rates
802.11a
Transmit
Rates
128 | Aruba Configuration Reference
Default Description
opensyst Select any encryption type to be supported in this SSID profile. The supported
em encryption types are as follows:
xSec—Encrypts an original Layer-2 data frame inside a Layer-2 xSec frame, the
contents of which are defined by the protocol. xSec relies on 256-bit Advanced
Encryption Standard (AES) encryption.
opensystem—No information sent to the client in plain text
static-wep—Static Wired Equivalent Privacy
dynamic-wep—Dynamic WEP with a key management service
wpa-tkip—Wi-Fi Protected Access with Temporal Key Integrity Protocol
wpa-aes—Wi-Fi-Protected-Access-Advanced Encryption Standard
wpa-psk-tkip—Wi-Fi-Protected-Access-Preshared Key-Temporal Key Integrity
Protocol
wpa-psk-aes—Wi-Fi Protected Access-Preshared Key-Advanced Encryption
Standard
wpa2-aes—Wi-Fi-Protected Access that adds AES and CCMP
wpa2-psk-aes—Wi-Fi Protected Access that adds Preshared Key and Advanced
Encryption Standard
wpa2-psk-tkip—Wi-Fi Protected Access that adds Preshared Key and Temporal
Key Integrity Protocol
wpa2-tkip—Wi-Fi Protected Access that adds Temporary Key Integrity Protocol
1 Drop-down menu allows you to specify the key index for Wired Equivalent Privacy.
N/A Enter WEP Key 1, and confirm the key in the Confirm field.
N/A Enter WEP Key 2, and confirm the key in the Confirm field.
N/A Enter WEP Key 3, and confirm the key in the Confirm field.
N/A Enter WEP Key 4, and confirm the key in the Confirm field.
N/A Enter the hex key to be used with Wi-Fi Protected Access.
N/A Enter a difficult-to-guess passphrase between eight and 63 characters.
1 Enter the Delivery Traffic Indication Message that informs wireless clients about the
presence of buffered, multicast, or broadcast data on the AP. The DTIM interval
specifies the beacon frequency that synchronizes the AP to the network. This setting
supports 1 to 255 milliseconds.
1000 Enter the amount of time, in minutes, that a client is unseen by any probes before it is
deleted from the database. Enter 0 to disable ageout.
All Specify the total transmit rates for the 802.11g radio. The AP attempts to use the
selected highest transmission rate to establish a mesh link. If a rate is unavailable, the AP goes
through the list and uses the next highest rate. All transmission rates are selected and
used. If you do not select 802.11a or 802.11g transmit rates, all rates are selected by
default when you click Apply.
1 and 2 Specify the basic rates for the 802.11g radio.
selected
All Specify the transmit rates for the 802.11a radio. The AP attempts to use the highest
selected transmission rate to establish a mesh link. If a rate is unavailable, the AP goes through
the list and uses the next highest rate. All transmission rates are selected and used by
default. If you do not select 802.11a or 802.11g transmit rates, all rates are selected
by default when you click Apply.
AirWave Wireless Management Suite | Configuration Guide