Dell PowerConnect W-Airwave Configuration Manual page 125

Table 47 Aruba Configuration > Profiles > RF > Optimization Profile Settings (Continued)
Field
AP Load Balancing
Max Retries
(0-100,000)
AP Load Balancing
User High
Watermark
(0-100,000)
AP Load Balancing
User Low
Watermark
(0-100,000)
AP Load Balancing
Util High
Watermark
(0-100%)
AP Load Balancing
Util Low
Watermark
(0-100%)
AP Load Balancing
Util Wait Time
(0-360,000 sec)
Station Handoff
Assist
Detect Association
Failure
Coverage Hole
Detection
Hole Good RSSI
Threshold
(0-65,535)
Hole Good Station
Ageout (sec)
Hole Detection
Interval (sec)
Hole Idle Station
Timeout (sec)
Hole Poor RSSI
Threshold
(0-65,535)
Detect
Interference
AirWave Wireless Management Suite | Configuration Guide
Default Description
8 Set the maximum number of times that an AP attempts load balancing
before timing out.
0 Set the high watermark level for the number of users that AP load balancing
is to support. The supported range is 0 to 100,000 users, and setting this
field to 0 users disables this function. When the number of users exceeds
the high watermark, it triggers an alert.
0 Set the low watermark level for the number of users that AP load balancing
is to support. The supported range is 0 to 100,000 users, and setting this
field to 0 users disables this function. When the number of users exceeds
the low watermark, it triggers an alert.
0 Set the high watermark level as a percentage of load balancing utilization.
The supported range is 0 to 100%, and a value of 0% disables this function.
When this watermark is exceeded, it triggers an alert or wait time.
0 Set the low watermark level as a percentage of load balancing utilization.
The supported range is 0 to 100%, and a value of 0% disables this function.
When this watermark is exceeded, it triggers an alert or wait time.
0 Set the wait time for the AP when AP load balancing is enabled. When load
balancing thresholds are exceeded, this setting defines the length of time
before AP load balancing restarts on the AP. The supported range is 0 to
360,000 seconds, and defining a value of 0 disables this function.
No Enable or disable the ability of APs to hand users over to another adjacent
AP, as available, in order to optimize or improve general network load.
No Enable or disable an AP's ability to detect failures in wireless user
associations.
No Enable or disable an AP's ability to detect areas where an otherwise good
RF signal is not reaching wireless clients to an adequate level.
This setting requires a Wireless Intrusion Protection license.
20 Set the amount of time in seconds during which Received Signal Strength
Indication (RSSI) is to check coverage holes.
This setting requires a Wireless Intrusion Protection license.
30 Set the amount of time in seconds that an AP is unseen by any probes
before it is deleted from the database. Enter 0 to disable ageout.
This setting requires a Wireless Intrusion Protection license.
180 Sets the amount of time in seconds in which automatic hole detection
should check for coverage holes. Enter 0 to disable this function.
This setting requires a Wireless Intrusion Protection license.
90 Sets the amount of time in seconds before which an idle AP is deleted from
the database, once it has become idle. Enter 0 to disable this function.
This setting requires a Wireless Intrusion Protection license.
10 Sets the threshold at which RSSI deems coverage to be poor.
No Enables or disables interference detection for the APs to be configured with
this optimization profile.
Aruba Configuration Reference | 125