NEC Express5800 Series User Manual page 141

Select SAS/SATA Disk and press <Enter>
Device Box Slot
#0 FF
#1 00
#2 00
#3 00
#4 00
#5 00
#6 00
#7 00
#8 00
#9 00
#10 00
#11 00
#12 00
#13 00
#14 00
Drive with + sign is Bootable
Use Page Up or Page Down keys to move to next page
See the following table for each item.
Item
Format Disk
Verify Disk Media
Indicate LED
Write Cache
Setting
Connection Rate
Set Bootable
Adaptec SAS/SATAController#0
Model
FF HITACHI HUS151436VLS300
FF No device
FF No device
FF No device
FF No device
FF No device
Format Disk
FF No device
Verify Disk Media
FF No device
Indicate LED
FF No device
Write Cache Setting
FF No device
Connection Rate
FF No device
Set Bootable
FF No device
FF No device
FF No device
FF No device
Parameter
―
―
―
Enabled
[Disabled]
[Auto]
1.5Gb/s
3.0Gb/s
Enabled
[Disabled]
[ ]: factory-setting
FW Rev
Description
The disk is initialized by writing the entire disk with
zeroes.
TIPS:
Low-level formatting is performed at the factory.
You will not need to perform low-level format again.
IMPORTANT:
All the data on the disk is deleted. Back up your data
before performing this operation.
Check for errors by scanning the disk drive media
Flash the LED on the selected disk drive.
Enable/Disable Write Cache.
The data transfer rate of disk drive. The initial value is
set to [Auto]. You do not need to change it.
Set the disk drive to the bootable disk drive. You do
not need to change it.
System Configuration 4-41
A340