7. Using the UV.CHK screen (only available in online mode).
...
Displays all UJ35 controller information in real time.
...
Enables measurement calibration of optional UV sensor and set UV strength values.
・LED status for each CH differentiated by color
・If an error occurs, an error number is displayed
・Panel showing error list can be displayed at any time
・Shows measured value in real time
・[TYPE]
・[TEMP.]
・[ERROR No.] Displays error list panel.
1) "Measurement"... Shows measured UV strength of selected CH.
*When values are being changed for a CH (1–4), Set strength (1–100) is highlighted.
・[CH SELECT]
・[Set strength (1-100%)]
during measurement.
・[Measured value (W/cm
・Write
・Low Range
・High Range
・START
・STOP
2) "Calibration"... For the selected TYPE, corrects the UV strength for CH and STEP.
・[CH SELECT]
・[Set strength (0.00-49.9W/cm
・[Measured value (W/cm
・[Calibration strength (%)] Shows strength (%) during calibration.
・Write
・Low Range
・High Range
・START
・STOP
・RESET
・ERROR No.
Displays the current TYPE (0-7).
Constantly shows the LED temperature for each connected CH.
Selects the CH to be measured.
Enables entry of strength (%) to be measured, can be changed
2
)] Shows measured value in real time.
Uploads UV entered strength (%) to UJ35 controller.
Sets measurement range to 0.00-9.99 W/cm
Sets measurement range to 0.0-49.9 W/cm
Starts irradiation on the selected CH.
During irradiation, performs emergency stop.
Selects the CH to be calibrated.
2
)]
Enables entry of strength (%) to be calibrated.
2
)] Shows measured strength in real time.
Uploads UV entered strength (%) to UJ35 controller.
Sets measurement range to 0.00-9.99 W/cm
Sets measurement range to 0.0-49.9 W/cm
Starts irradiation for calibration.
Performs emergency stop during calibration.
Resets errors.
Displays error list panel.
External control
2
.
2
.
2
.
2
.
45