Panasonic KX-T336 System Reference Manual page 524

1.01 INS (In Service) Command
Description
Changes the status of the target device ,shelf,
Refer to Section 14-F "Functional Test by
card, port, station etc.) to "In Service" in on-line
Entering Commands" for details about test
communication mode.
command.
Conditions
The status of the specified devices (she?. card,
port, station) should be "OUS" or "FAULT.'
When you change the status of a lower device
(port, station) to "INS," the upper device [shelf,
card) should be changed to "INS" status
beforehand.
If you try to change the lower device (port,
station) status to "INS" while upper device (shelf,
card) is in "OUS" status, the error message
"Invalid Status" appears on the screen.
When you change the status of an upper device,
the status of lower devices changes as follows.
Upper device
Lower device
OUS - INS
OUS - INS
Fault - Fault
Operation
Upper device
Fault --t INS
Lower device
Fault ----t INS
ous - ous
Normal operation
The following message appears on the screen.
l
**** OK
Press the function key INS.
Operation failed
An error message apears on the screen in the
following cases.
CMD> In Service No. = xxxxxx
Enter the number of the desired device.
For input values, see below:
l
Parameter error
l
Not installed
l
Status error
l
INS failure (Diagnostic error) . .
Device
Input Value
Shelf 1 to 3 (physical number)
Card
101 to 315 (physical number)
Port
1011 to 3158 (physical number)
Station DNxxxx (xxxx: extension number;
three or four digits) or Physical
number: four digits
AT-I- Al orA2or
Physical number: four digits
DTMF Rxxxy (xxx:Card number; y: t or 2)
CNF CFBxx or CFOyy (xx: 01 to 08.
yy: 01 to 64)
14-C-2