Panasonic KX-T336 System Reference Manual page 392

1 To change the default setting 1
(Deactivating the polarity reversal detection)
1.
At the programming prompt (PRG>). type:
+ ;PRG>PRDAT (L)
The screen displays the input prompt (INPUT >>) as follows:
; PRG> PRD AT
; Equipment No.2011 . . . . . . . . . . . . . . .._ Y
+;
INPUT >>
2. At input prompt (INPUT >>), type:
; PRG> PRD AT
; Equipment No.2011 . . . . . . . . . . . . . . . . . Y
+;
lNPUT>>N (J)
The screen displays the next input prompt (INPUT >>) as follows:
; PRG> PRD AT
; Equipment No.2011 . . . . . . . . . . . . . . . . . Y
.
t
INPUT >> N
; Equipment No.2012 . . . . . . . . . . . . . . . . . Y
+;
INPUT >>
. 3. Follow the step 2 for other CO line ports of an R-LCOT card.
4. To store the new assignments to the system,
at input prompt (INPUT >>), type:
; PRG> PRD AT
; Equipment No.2011 . . . . . . . . . . . . . . . . . Y
,
INPUT >> N
; Equipment No.2012 . . . . . . . . . . . . . . . . . Y
t
INPUT>> N
I
.:
; Equipment
Lo.2013 . . . . . . . . . . . . . . . . . Y
I
INPUT >> N
; Equipment
No.2011 . . . . . . . . . . . . . . . . . N
+
INPUT>> $EOD (J)
. .
This assigns the new setting to the system, and the programming prompt
(PRG >) appears again.
To finish the programming
At the programming prompt (PRG >), type:
+ ;PRG>EXlT (J)
The screen displays the initial prompt ( > ) of the Dumb programming
mode as follows:
; PRG> EXIT
+ ;>
1 O-c-1 01
(30393)