Panasonic KX-T336 System Reference Manual page 453

6.00 Call Waiting Tone Selection
Used to choose desired call waiting tone type
from Tone 1 and Tone 2.
refer to Section 4-D-7.00 'Call Wahng.-
The explanation of the message display apokes
For further information about call waiting tone,
only to a PITS provided with the display.
Operation
Result
Comment/Note
I. Set the MEMORY switch at
l
The following message
l
This display is called "Initial
the rear of PITS to
appears on the display: display for PITS station
"PROGRAM."
programming mode."
L?!l
PIT-PGM No.? +
l
If the following message
SET.. PlIcGRM4
appears on the display, the
ME&low
l
The MEMORY button indicator
programming data of your
lights in red.
PITS has already been
accessed by another
administration device.
Already accessed
l
From now on, in any status,
pressing the END button
restores this status.
!. Dial "02."
l
The preset tone type appears
l
If nothing is entered within one
p!jJq
on the display:
minute after dialing "02," "Initial
display for PITS station
'y?%%Gay
programming mode" is shown
again on the display.
. .
l
The MEMORY button indicator
light goes out.
;. To change the preset tone
l
To change the assignment,
type, dial the number
simply dial the appropriate
corresponding to the desired
number again.
call waiting tone.
l
To set the call waiting tone 1,
l
The following message
dial "1."
appears on the display:
•l
1
C.W. Tone-l
1
l
The following message
appears on the display:
l
To set the call waiting tone 2,
dial "2."
C.W. Tone-2
•l
ABC
2
Continuec
12-c-21