Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01091
28.9
Action
"Access"
Scroll to menu A9
"A"
"A"
Rev: 3
Activate address setting mode for DU
(H5/A9)
This function can be used by commissioning / service engineer to
activate the address setting mode in the following Display Units
connected to the RS485 interface in EBL128:
Ext. Presentation unit (EPU) 1728
Alert Annunciation unit (AAU) 1735 / 1736
Ext. Fire Brigade Panel (FBP) 1826 / 1828
A specific unit or all units can be activated for address setting.
NOTE! The units have to be in operation and in quiescent condition,
i.e. the units have to have an address set already.
Text in display
Disconnect / Re-connect COM loop
Activate address setting mode for DU
Activate address setting mode for
DU 0
(9 = All)
Activate address setting mode for DU
The address has thereafter to be edited in the unit respectively.
EBL128 Operating Instructions V1.1.x
ACCEPT? A1
ACCEPT? A9
ACCEPT?
ACCEPT? A9
114
Comments
According to chapter
"Access code for service
and maintenance", see
page 104.
Write the unit's address.
9 = All units.
Press "A" to accept.
Scroll or press "Return" to
H5. Scroll or press
"Return" to log off.
Advertisement
Table of Contents
