Table of Contents
Advertisement
LAMP REPLACEMENT
6.
Without installing the tamp cover, the power will be off and the Lamp Indicator will flash (see page 8). Be sure to install the lamp
cover by re-engaging the two clipsand tighten the screws before turning the power on, otherwise it may cause unusual colors,
r"
SCREW
m
F
LAMP COVER
O
milii
-.I
NOTE:
7.
IF POWER IS CONNECTED
BEFORE THE LAMP COVER IS INSTALLED, THE POWER WILL
BE OFF AND THE LAMP INDICATOR
WILL FLASH (SEE PAGE 8 ).
Install the front cover as shown below. Put the front cover beck in and align the snap on quick connect then push inwards hold-
ing the left and right side of the front cover until you hear a snap. Push the other snap on gently to make a good fit.
I
iJ m
8.
Plug power cord into AC outlet and turn on the main power switch.
-t
oooo
I
NOTE: This product contains lead and a lamp that contains mercury. Dispose of this product and its lamp in accordance with
applicable environmental laws. For lamp recycling and disposal information, go to www.lamprecycle,org. For product
recycling and disposal information, contact your local govemmant agency or the Electronic Industries Alliance at
www.eiae.org (in the US) or the Electronic Product Stewardship Canada at www.epsc.ca (in Canada).
For more information, call "1-800-HITACHI."
69
Advertisement
Table of Contents
