Hitachi 42V515 Operating Manual page 26

Lcd rear projection tv
Hide thumbs Also See for 42V515:
Table of Contents

Advertisement

HOW TO USE THE REMOTE TO
CONTROL
YOUR LCD REAR PTV
_)
VOLUME (VOL) WHEEL, MUTE button
Use the VOL WHEEL (& or V) until you obtain the desired sound level.
To reduce the sound to one half of normal volume (SOFT MUTE) to answer the telephone, etc., press the VOL wheel down. Press
the VOL wheel again to turn the sound off completely (MUTE). To restore the sound, press the VOL wheel one more time, or VOL
Up (A).
ii!i!_i!l,U
Closed Captioning will display automatically when MUTE/SOFT MUTE is on and Closed Caption is set to AUTO (see page 64).
When the TV power is turned off at a volume level 31 or greater, the volume level will default to 30 when the TV is turned on.
However, if it is set to a level 30 or less, the volume level will be at the level it was set when the "IV is turned ON.
CHANNEL (CH) WHEEL/CHANNEL SELECTOR buttons
The CHANNEL wheel or the CHANNEL SELECTOR buttonsare used to select channels, lock access code, etc, Use the CHAN-
NEL WHEEL (& or V) to select the desired channel. Use the CHANNEL SELECTOR buttonsto enter one, two, or three numbers
to select channels. Enter "0" first for channels 1 to 9, or simply pressthe single digit channel you wish to tuns then wait a few sec-
onds for the "IV to tune. Channel selection may also be performed by CHANNEL WHEEL up (A) or CHANNEL WHEEL down (V).
Press the channel (CH) wheel to switch to Favorite (FAV) channel mode. You will know you are in Favorite Channel mode when
(FAV) is displayed and the displayed channel is GREEN. Press it again to return to your regular tuned channels. You can add any
channel to your Favorite channel list by pressing and holding down the Channel (CH) wheel untilthe displayed channel turns from
WHITE to highlighted GREEN. You can also delete a channel from your favorite channel list by pressing and holding down the
Channel (CH) wheel until the displayed channel turns highlighted GREEN to WHITE,
(_) (-) DASH button
The DASH (-) button can only be used when the remote control is in Set-Top-Box (STB) mode.
(_) LAST CHANNEL (LC) button
Press this button to toggle between the current and last channel viewed.
26

Advertisement

Table of Contents
loading

Table of Contents