Table of Contents
Advertisement
USING THE REMOTE TO CONTROL
SET-TOP-BOX/SATELLITE
RECEIVER FUNCTIONS
J
Operating the precoded function for your set-top-box/satellite
receiver.
This remote is designed to operate different types of set-top-box/satellite systems. You must first program the remote to match the
remote system of your set-top-box/satellite systems (refer to pages 36-37 for pre-codes).
1.
Tum ON your set-top-box/satellite systems.
2.
Aim the remote control at the front of your set-top-box/satellite systems.
3.
To switch to set-top-box/satellite (STB) pre-coded mode, use the SOURCE ACCESS buttons (<1, I_) on the remote control to posi-
tion the LED light to the corresponding selection.
4.
Hold down the ENT button on the remote and enter the four digit preset code that matches your sat-top-box/satellite
receiver as
shown on page 36-37. Release the ENT button. The indicator light will flash 3 times if the code was accepted.
5.
Aim the remote at the sat-top-box/satellite receiver and press the POWER button. The remote will turn offyour set-top-boxisatel*
lite receiver when the correct four digit preset code is entered. When this occurs, the remote control is programmed for your set-
top-box/satellite receiver. If the set-top-box/satellite
receiver does not turn off, try a different four digit preset code.
6.
The remote will now control your set-top-box/satellite receiver.
NOTES:
1.
If your set-top-box/satellite
receiver cannot be operated
affer performing the above procedures, your set-top
box/satellite receiver code has notbeen precoded into the
remote.
2,
In the unlikely event that your set-top-box/satellite
receiver cannot be operated after performing the above
procedures, please consult your set-top-box/satellite
receiver operating guide.
3.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. Affer replacing the batteries repeat the
entire programming procedure as stated above.
(_
PRE-CODED SET-TOP-BOX/SATELLITE
RECEIVER
buttons
These buttons transmit the chosen pre-coded sat-top
box/satellite codes.
(_) EXCLUSIVE TV buttons
These buttonsare for operating the "IV.
Tv
_
c_
STe e_
/_p
©
©
©
•
©
©
S_JRCE_S
-..©©
i
f
@ @ N
®® ®!
i
HITACHI
-O
--O
MY SATELLITE
RECEIVER/STB
CODE IS:
!:3:iii_iil
NOTE:
Refer to instruction manual of the set-top-box/satellite
receiver for operation of the buttons exclusively for the sat-top-
box/satellite receiver,
31
Advertisement
Table of Contents
