Using The Remote To Control Cable Box Functions - Hitachi 42V515 Operating Manual

Lcd rear projection tv
Hide thumbs Also See for 42V515:
Table of Contents

Advertisement

USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS
Operating the precoded function for your cable box.
This remote is designed to operate different types of cable boxes. You must first program the remote to match the remote system of
your cable box (refer to pages 36-37 for pre-codes).
1.
Tum ON your cable box.
2.
Aim the remote control at the front of your cable box.
3,
To switch to Cable (CBL) pre-coded mode, use the SOURCE ACCESS buttons(4,
b-) on the remote control to position the LED
light to the corresponding selection.
4.
Hold down the ENT button on the remote and enter the four digit preset code that matches your cable box as shown on pages 36-
37. Release the ENT button. The indicator light will flash 3 times if the code was accepted.
5.
Aim the remote at the cable box and press the POWER button. The remote will tum offyour cable box when the correct four digit
preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off,
6.
iii _iiiiii!_?
1.
Z
i !iii!iU.Iii!
3.
!_i!i ili! I Jl.Ii
try a different four digit preset code.
The remote will now control your Cable box.
NOTES:
If your cable box cannot be operated after performing the
above procedures, your cable box code has not been
precoded into the remote.
In the unlikely event that your cable box cannot be
operated after performing the above procedures, please
consultyour cable box operating guide.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
](_ PRECODED CABLE BOX buttons
These buttonstransmit the chosen preoeded cable codes.
(_
EXCLUSIVE TV buttons
These buttonsare for operating the TV.
s0_c_ _x_ss
,--- :,© © @:
_,u
0
J
@ G ®i
@ @ @:
HITACHI
MY CABLE BOX CODE IS:
NOTE:
Refer to instructionmanual of the Cable Box for operation of the buttonsexclusively for the Cable Box.
]
3O

Advertisement

Table of Contents
loading

Table of Contents