Advertisement
Available languages
Available languages
Important
Safety
lrestr.ctiores
for Battery
C#argers
SAVE THESE INSTRUCTIONS:
Th,;s manual
contains
important
safety ,_nstructiens for battery charger&
*
Before using charger, read all instructionsand cautionary markings
on charger, battery pack, and product using battery pack.
A DANGER: 120 vo/_:s are present at charging termina,ts. Do not probe
with conductive objects. Flectric shock or electrocution may resdL
WARNING: Do not allow any liquid to get inside charge_ Electric
shock may result.
AOAUTION:
To reduce the risk of #_jury, charge only DEWALTnickel
cadmium rechargeabte batteries. Ot,_er types of batteries may burst
causing persona/iX, jury and damage.
_ CAUTtON: Under certain conditions, wh.# the charger plugged in to
t,_e power suppt_ the exposed charging contacts inside t,_e charger
can be shorted by foreign material. Foreign materia,ts of a conductive
nature such as, but not limited to, steel wool, aluminum foil, or any
buildup of metah;ic particles should be kept away from chat:ger cavities.
Always unplug the charger from t,#epewer suppty when there,is no bah
tery pack ,_t_ t he cav/tj4 Unplug c,_arger before attempting to clean.
*
DO NOT attempt to charge the battery pack with any chargers
other than the ones in this manual
The charger and battery
pack are specifically designed to work toget,_er.
*
These chargers
are not intended
for any uses other
than
charging
DEWALT rechargeable
batteries. Any other uses may
result in risk of fire, electric shock or electrocution.
*
Do not expose charger to rain or snow.
*
Pull by plug rather
than cord when disconnecting
charger.
This wilt reduce risk of damage to electric plug and cord.
*
Make sure that cord is located so that it will not be stepped
on,
tripped over, or otherwise
subjected
to damage or stress.
*
Do not use an extension
cord unless it is absolutely
neces-
sary. Use of improper extension cord could result in risk of fire,
electric shock, or electrocution.
* An extension
cord must
have adequate
wire size (AWG or
American
Wire Gauge) for safety. T, S e smah'er the gauge number
of the wire, t,#e greater t,_e capacity of t,#e cable, that is 16 gauge
has more capacity than 18 gauge. W,_en using more than one
extension to make _o the total length, be sure each individual
extension contains at least t,#e minimum wire size.
Recommended
Minimum
Wire Size for Extension
Cords
TotamLength of Cord
25ft.
50ft.
75ft.
100ft.
125ft.
150ft.
175ft.
7.6m
15.2m
22.9m
30.5m
38.1 m 45.7m
53.3m
Wire Size AWG
18
18
16
16
14
14
12
.
Do not place any object on top of charger or place the charg-
er on a soft surface that might block the ventilation
slots and
result in excessive
internal
heat. Place the charger in a position
away from any heat soume. The charger is ventilated through slots
in the top and the bottom of the housing.
*
Do not operate charger
w#h damaged
cord or plug-
have
them replaced immediatetJ4
*
Do not operate charger
if it has received
a sharp blow, been
dropped,
or otherwise
damaged in any way. Take it to an autho-
rized service center.
*
Do not disassemble
charger;
take it to an authorized
service
center when service or repair is required.
Incorrect reassembly
may result in a risk of electric shock, electrocution or fire.
*
Disconnect
the charger from the outlet before attempting
any
cleaning.
This will reduce the risk of electric shock. Removing
t,_ebattery pack will not reduce t,_is risk.
*
NEVER attempt to connect 2 chargers together.
*
The charger
is designed
to operate
on standard
household
electrical
power (t20 Volts). Do not attempt
to use it on any
other voltage. This does net apply to the vehicular charge_
Advertisement
