Installing Cutter Guard Spring - Craftsman 113.20680 Owner's Manual

: ! .,..---SPRING
:I_ST_LLI:NG :CUTTER GUARD SPRING:: : FLAT WASHER _"-"
SPRING 1
\ suPPORT I
::'::: t, Remove €otter pin from pivot pin in cUttePguard:and \ LOCK -_PLATE /
remove guard (located underneath infeed table.) WASHER"_., /
Spring must appear in sketch from underside of in- _ _'_ BUSHING
as SCR EW
feed table, it will not perform properly if installed
upside down.
i
i
!,
VIEW LOOKING UP
FENCE
IN PLACE
CUTTER
GUARD
1. Position guard as shown, with PIVOT PIN above hole
in infeed table.
2, Align SLOT in pin with TANG in spring, and press
down,
3. Replace cotter pin:
_OL[_' IN
_INFEED
TABLE PIVOTPIN
r ..... i
4. RAISE end of FENCE, rotate guard COUNTER
clockwise only enough to CLEAR fence,
5. LOWER fence and tighten: bothknobs.
:i:Y•::!ii•::•:
LIFT
:_OTATE
COUNTER
CLOCKWISE
FENCE
24