Jointer-Pulley Belt Guard Installation - Craftsman 113.20680 Owner's Manual

.
10,
11.
12.
13,
Remove knob and washer.., lift guard up.
Place belt onto Jointer pulley by rotating the pulley.
MAKE SURE BELT HAS NOT SLIPPED OFF OF
MOTOR PULLEY.
Move motor sideways so that both pulleys are in line.
PUSH downward on motor to apply tension to belt and
tighten nuts on motor mounting bolts.
NOTE: It is only necessary to tension the belt so that it
does not slip while running,
If you cannot obtain sufficient tension with motor push-
ed all the way down, remove the four motor bolts and
insert them in LOWER set of holes.
NOTE: To remove guard, lift up on LONG TABS of
clips. ,. pull guard outward. The clips should remain on
BELT GUARD SUPPORT.
JOINTER-PULLEY BELT GUARD
INSTALLATION
1. Attach guard to stand with Hex. Hd. screws and nuts,
Make sure belt does not scrape on guard.
2. Replace washer CONCAVE side up... screw on knob,
BOLT.
WASH ER
(CONCAVE
SIDE UP)