Cub Cadet i1046 Operator's Manual page 91

Deck Rear Roller Adjustment
The rear rollerson the mowerdeck are notdesignedto
carry the weightof the deck,The rear rollersshouldbe
adjustedto approximately 1/4"to 1/2"abovethe ground
whenthe deck is movedto the desiredcutting height,
Placethe tractoron a smooth,flat surface,movethe deck
to the desiredcuttingheight,and checkthe heightof the
rear rollers,If contactingthe ground,or above1/2" from
the ground,adjust the rear rollersas follows:
46" Deck ONLY
The 46"deck rollerassemblyindexbrackethasthree
adjustmentpositionsusingeitherthe bottomtwo holes,
middletwo holes, or top two holes.
• Supportthe rollerassemblyand removethe two self
tappingscrewsfrom boththe left and rightroller index
brackets,
• Positionthe rollerassemblyso that the rollersare ap-
proximately1/4"to 1/2" abovethe flat surfacebelow,
Align the nearesttwo indexbracketholeswith holesin
the deck mountingbrackets,See Figure13,
• Securethe rollerassemblywith thefour self tapping
screws.See Figure13.
NOTE: Theself tappingscrewsshouldbe in the
corresponding holesof boththe left and rightrollerindex
brackets,
Roller Index Brkt.
0
Self Tapping
Screws
Figure 13
50" DeckONLY
The50" deck rollerassemblyindexbrackethasfive
adjustmentpositionsholes,
• Whilesupportingthe rollerassembly,removeclick pin
and withdrawthe clevispin from boththe left and right
roller indexbrackets,See Figure14,
Index Brkt.
Click Pin
Clevis Pin
Figure 14
• Positionthe rollerassemblyso that the rollersare ap-
proximately1/4"to 1/2"abovethe flat surfacebelow.
• Alignthe nearestindexbracketholeswith the holes
in the deck mountingbrackets.Insertthe clevispins
throughthe deck bracketsand the indexbracketsand
securewith the click pins.See Figure14.
NOTE:The clevispinsshouldbe in the corresponding
holesof boththe left and right rollerindexbrackets.
ustments
WARNING
Neverattem pt
to makeany
adjustments w hile
the engine is
running, except
wherespecified
inthe operator's
manual. S topthe
enginebefore
performing any
adjustments.
19