Sony Grand Wega KF-60DX100 Operating Instructions Manual page 7

Safety
Check
Upon completion of any service or repairs
to the set. ask the service technician to
perform routine safet) checks (as specified
by the manufaaturerJ to determine that the
set is in safe operating condition, and to so
certff 3 When the set reaches the end of its
usefnl life. improper disposal could result
in a picture tube implosion, Ask a qualified
service technician to dlspose of the set
For Safety
Be careful when moving
the LCD Projection TV
When you place the LCD Projection
FV in position, be careful not to
drop it on ':our foot or fingers.
Watch your footing while installing the LCD Projecnon
FV,
Carry the LCD Projection TV in
the specified manner
if you carry the LCD Projection TV in a
manner other than the specified manner
and without the specified number of
persons, it may drop and a serious injur_*
may be caused. Be sure to follow the instructions
mentioned below,
_1 Carry the LCD Projection TV with the specified
mlmber of persons tsee page 18).
-I Do not cart 3 the LCD ProJection TV holding the
speaker grill.
..I Hold the LCD Prq ection TV tightly when carrying
It,
About the LCD Projection TV
Although the LCD projection TV is made with high-
precision technology, black dots may appear or bright
points of light (red. blue. or green) may appear constantly
on the LCD screen. This is a structural property of the
LCD panel and is not a malfunction.
Installation
LI if direct sunlight or other strong illumination shines
on the screen, part of the screen appears white due to
reflections from behind the screen. This is a
structural propert.'- of the LCD Projection TV.
Do not expose the screen to direct illumination or
direct sunlight.
The picture quahty ma3 be affected by your vmwmg
position, if you view the TV close to you, you may
suffer from eye fatigue.
For the best picture quality, install your LCD
projection TV according to the operating
instructions.
Sit at least 2.2 m (approx_ 7 ft.) away from your
LCD projection TV. and within 60 ° of the vertical
viewing area. and 130 ° of the horizontal viewing
3re_l.
When installing your LCD Projectmn TV against a
wall. keep it at least l0 cm (4 inches) from the wall.
Projection lamp
LI Your LCD projechon TV uses a projection lamp as
its light source, When the projection lamp wears out
after using the LCD projection TV for a long period
of time. the screen image becomes dark. or no image
will appear on the display. If the lamp replacement
indicator of the front panel blinks in red. replace the
lamp with a new one not supplied), in some cases.
the l_mp bursts inside the lamp unit noisily, but the
lamp unit is securely designed so that the pieces of
broken glass remain inside the lamp umt./See
-'Replacing the Lamp" on page 13.
Cooling fan
L.I This LCD projection TV uses a cooling fan to
prevent the internal temperature from heating up
You might hear the noise from the cooling fan,
depending on the place you install the LCD
projection TV.
7