Canon Vb-C60 - Ptz Network Camera Start Manual page 62

Built-In Terminal
External Device Output Terminals (OUT1, OUT2)
The external device output terminal consists of two pairs of output terminals (OUT1, OUT2), which
are nonpolar. The Viewer switches the 2 output terminals to disconnected or connected condition.
The output terminals use photo couplers and are separate from the internal circuit in the VB-C60.
A load to the output terminals should be within the following rated range:
Internal Connection Chart
The wire appropriate for external device cable is as follows.
Single wire AWG
Tip
Conductor diameter:
Strip the cables back roughly 8 or 9 mm (0.315 - 0.354 in).
3-6
Rating across the output terminals: Max. 50VDC
Continuous load current: 100mA or less
10k Ω 10k Ω
0.1 µ F
: # 28 - # 22
0.32 - 0.65 mm (0.013 - 0.026 in)
ø
+3.3V
10k Ω
+
Input terminal
External
IN1, IN2
device
-
Output terminal
External
OUT1, OUT2
device