Ceiling-Mounting With Ceiling Mount Cover Ss60-S-Vb/Ss60-B-Vb (Option) - Canon Vb-C60 - Ptz Network Camera Start Manual

Using a Tripod
The screw hole for tripod mounting is on the bottom of the camera.
Always use a tripod mounting screw that is less
than 5.5 mm (0.22 in.) in length. The use of screws
Note
5.5 mm (0.22 in.) long or longer could damage
the camera. Also, the tripod seat used should be
at least 30 mm (1.18 in.) in diameter.

Ceiling-Mounting with Ceiling Mount Cover SS60-S-VB/SS60-B-VB (Option)

Follow the steps below to mount a camera on the ceiling. Install the camera securely.
Carefully read and observe the precautions in "Before Installation" ( → P.2-14).
Note
a WARNING:
Please contact the dealer where you purchased the camera, for installation
and checkups.
● The place or ceiling, to which a camera is installed, should be strong enough to
bear the weight of the camera plus its optional products, including Ceiling Mount
Cover and Indoor Dome Housing. Be sure to reinforce the ceiling as needed.
● Please be sure to regularly check for rust on screws and brackets and for screw
loose, to avoid injuries or damages to the camera caused by camera falling.
● It is not recommended to install the camera to places with heavy vibration. It may
cause mechanical problems.
● When wiring cables, pay much attention not to damage the indoor wiring or piping.
Side View of mounting
Roof space
Ceiling Bracket
Safety Wire
Fix to an anchor
or structure
Step4 Camera Installation
30mm
(1.18inch)
or wider
LAN cable
Ceiling board
VB-C60
5.5mm
(0.22inch)
or shorter
Tripod
mounting
screw
2-15