Menus; Setup > System - NorthStar EXPLORER AP380 Installation And Operation Manual

6 Menus

Many of the Explorer AP380 features and
functions are operated through menus.
• To scroll through menu items, scroll through
items in a list or change data use the Control
Dial. Clockwise scrolls across/down or
increments data.
• To select a menu item press
• To go back to the previous menu
press .
• To accept changes press
• To discard changes press
Note: Some menu items in the Explorer AP380
menus utilize checkboxes.
• If the box is 'checked' (contains a check or
tick), then that function is selected (enabled)
or ON.
6-1 Setup > System
Language
Select the language for the display. The options
are: English, Italian, French, German, Spanish,
Dutch, Swedish, Portuguese, Finnish and Greek.
Tip: In case you can't read the current
language, the language setting is the first
item in the system menu.
Backlight
The backlight pop-up is displayed (see also
section 3-4).
The bar setting represents the current level of
backlighting.
Night Mode –Allows low contrast Night mode.
Auto – allows night mode to be selected in
backlight pop-up
On – night mode is active all the time
Off – night mode is not available
.
.
.
Northstar Explorer AP380 System Installation and Operation Manual
• If the box is 'un-checked' (does not contain a
check or tick), then that function de-selected
(disabled) or OFF.
• To select or de-select a checkbox, highlight
the menu item using the Control Dial and
press . The change will happen
immediately.
The main menu for configuring the Explorer
AP380 is the Setup menu. Press
Setup menu is displayed (normally twice).
The Setup menu and options are summarized
in this chapter. The factory default settings are
shown where applicable. Each Setup menu
option is explained in the following sections.
Key beep
Enables or disables an audible beep when a
key is pressed or Control Dial is rotated.
Auto power off
Select to have the AP380 power off
automatically every time the boat's ignition
is switched off. This applies only if the display
unit is wired for Auto Power (see installation
manual).
About
Displays information about the unit.
Factory Reset Resets all settings to the factory
default settings. A warning box asks: Are you
sure? Select Yes and press
No or to cancel.
Main control unit – Resets the MCU's
settings
Head unit – Resets just this head unit's
settings
Both – Resets the MCU's settings and this
unit's settings
SmartCraft™ Select to enable SmartCraft
functions. SmartCraft is only available with
certain Mercury engines, and requires a
SmartCraft Gateway. For more information
refer to the SmartCraft manual included with
the SmartCraft gateway.
until the
to confirm, or
57