Display > Autopilot - NorthStar EXPLORER AP380 Installation And Operation Manual

4-2 Display > AutoPilot
Displays an advanced AP380 display with essential AP380 data.
Display area
Data Header
1
Heading
2
Drive
3
indicators
Numerical data
4
panels
Bar data
5
panels
Mode panel
6
Options menu:
Header Menu for configuring the data header in this
display (see section 5).
Data setup Enters the data set-up mode. Use the Control
Dial to highlight a data cell, press
types that can be displayed in that cell.
Function
Customizable data cells. Each display page has a separate header
configuration. Default: Voltage, Current, Alarm Status (see section 5).
Large digits show the heading of the vessel
Left and right boxes 'fill up' to indicate when the AP380 is driving the rudder
and how much power is being used by the drive system
Customizable data cells. Default: Course to steer, Course error.
Customizable indicator bar. Default: Automatically switches between Rudder
angle, Course error and Cross track error.
Left hand side: shows the steering mode (COMPASS, GPS, WIND)
Right hand side: shows the operating mode (Standby, Auto, H-Steer) inside a
colored tab.
Panel changes to blue when in AUTO mode. The colored tab is yellow in
STBY mode, green in AUTO mode, magenta in H-STEER mode and red
when there is a critical alarm.
to display a list of data
Northstar Explorer AP380 System Installation and Operation Manual
AutoPilot displays
1
2
3
4
5
6
53