Canon VB101 User Manual page 42

Detail Settings
c
Note
42
For the packet target address in the connection keeping function, we
recommend that you consider the impact on traffic conditions and set the IP
address that is nearest after the auto dial-up router.
Internet
Click the [OK] button to change the settings. To discard the changes, click the
[Cancel] button. This returns you to the settings title page.
Static Route Control
Route
communicating with a wide-area network
through a router. When using both Ethernet
and PPP, set the route as needed.
"Default route"
The same setting can be made at "Default
gateway address" on the Basic Settings
settings page. Specify the route that
would normally be used. A gateway
address is required if a router on the
Ethernet side is used.
"Route 1-3"
Use this setting if you require connection
routes other than the normal route. You
can select either Ethernet or PPP as the
interface. Specify the destination route in
the Destination and Mask fields. You must
specify a gateway address if you are
using a router on an Ethernet network.
Connection Keeping
"Send packet regularly"
When this is selected, an ICMP Echo
packet is transmitted periodically to a
specified address in order to maintain the
network connection.
"Target Address"
Specify where the PING should be sent.
"Interval(min)"
In minutes from 1 to 60, specify the
interval at which PING should be sent.
Router
ISDN/leased line/
ADSL, etc
settings are required
VB101
when