Canon VB101 User Manual page 155

GS023 The erase count for the on-board flash ROM exceeded the limit (err)
FlashROM erase count(%1)exceeded the limit
Message
Erase count for the on-board flash ROM
%1
Explanation The erase count limit for the on-board flash ROM has been exceeded.
Response Contact an authorized Canon service representative.
If you continue to write data after this error occurs, there is a risk of data corruption.
Remote firmware upgrade-related log messages
II001 Remote firmware upgrade write error (err)
cannot reboot as the firmware is broken
Message
Explanation Reboot cannot take place because there is an error in the firmware that was written onto read-only memory during
the firmware remote upgrade. This error is not a transfer error and has not occurred as a result of a break in transfer.
This type of error occurs only when firmware is erased from the ROM or when firmware is written onto the ROM.
Contact your local Canon service representative. There is a possibility that the flash ROM chip has been damaged.
Response
II002 Application program is stopped because of the remote firmware upgrade (info)
application is halted for updating the firmware
Message
Explanation The application program has been stopped so that the firmware can be installed remotely. All operations
that are underway will be discontinued, and new commands for WebView, picture recording and
external device output control will not be accepted until a reboot has been carried out.
II003 Remote firmware upgrade completed (info)
firmware is updated
Message
Explanation The remote firmware upgrade process has been completed.
II004 Remote firmware upgrade time-out (warnning)
reboot as the firmware update time is out
Message
A reboot has been carried out because the remote firmware upgrade process performed a time-out.
Explanation
It occurs when communication with the client has been cut for more than 5 minutes due to network error etc.
The VB101 has restarted, since remote firmware upgrade processing timed out. Depending
Response
on the network error, this happens when communication from the client has stopped for at least
5 minutes or more.
Log Messages
7
155