HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server Manual page 10

Note
10 Latest News: Firmware Version 5.30
Disabling IPX
As long as IPX remains enabled, clients without the speci-
fied pure IP or NetWare/IP support will be routed through a
Novell server with an IPX/IP gateway. You can disable the
IPX protocol on the page described below in step b if all
clients are running the specified IP protocol binding.
b. Use the configuration page for NCP protocols: Start the web
browser, access the web page for the server, and select the
Quick Setup tab. Click the Detailed View icon. On the
resulting Protocols page, click the NetWare (NCP) tab.
Near the bottom of the page, click the checkboxes for the
three protocols—Enable IPX, Enable PureIP, Enable
NetWare/IP—to disable or enable each one as you decided
after referring to the table under step a above (page 9). See
the illustration below.
(If you set Enable NetWare/IP, also specify the DSS Server if
one is used.)
4. After the server is restarted and a delay of about 5 minutes, clients
that support the newly specified protocols will connect directly to
the server peer-to-peer.
If the clients cannot then access the server, do the following:
a. Switch off the power to the server.
b. Wait 20 minutes for the SAP table to be flushed.
c. Switch on power to the server.
d. Wait 5 minutes for the server to be visible. Try access again.