Fuji Xerox Color J75 Press Service Manual page 795

(2) Remove the Pulley.
(3) Remove the Decurler Drive Belt.
Figure 2 j0ib43737
Replacement
1. To install, carry out the removal steps in reverse order.
2. Install the Decurler Drive Belt as shown in the figure. (Figure 3)
Figure 3 j0ib43738
Ver.1.1
Color J75/C75 Press
REP 37.6.1 Inlet Chute Upper/Lower
Parts List on PL 37.6
Removal
WARNING
When turning OFF the power switch, check that the "Data"
lamp turns OFF. Press the <Job Status> button to check that
there are no jobs in progress/waiting in the queue. Turn OFF
the power switch and make sure that the screen display turns
OFF.
Turn OFF the main power switch, check that the "Main Power"
lamp has turned OFF, turn OFF the breaker and then unplug the
power plug.
1. Remove the Decurler Belt Upper/Lower. (REP 37.5.1)
2. Remove the block at the front upper side. (Figure 1)
(1) Remove the screw.
(2) Remove the spacer.
(3) Remove the Bearing.
(4) Remove the KL-Clip.
(5) Remove the block.
Figure 1 j0ib43739
3. Remove the Bearing at the rear upper side. (Figure 2)
(1) Remove the screw.
(2) Remove the spacer.
(3) Remove the Bearing.
02/2013
4-107
Figure 2 j0ib43740
4. Remove the pin at the front upper side. (PL 37.6)
5. Remove the Decurler Cam Position Sensor Assembly. (Figure
3)
(1) Remove the screw (x2).
(2) Remove the Decurler Cam Position Sensor Assembly.
Figure 3 j0ib43741
6. Remove the pin at the rear upper side. (Figure 4)
(1) Remove the screw.
(2) Remove the Pin.
37. I/F Module (Color C75 Press)
Disassembly/Assembly and Adjustment