Fuji Xerox Color J75 Press Service Manual page 840

Color J75/C75 Press
Ver.1.1
Figure 10 j0sa43932
Replacement
1. To install, carry out the removal steps in reverse order.
2. When installing the Clutch Bracket, affix the tab of the Clutch
Bracket to the cutout of the Bypass Clutch 3. (Figure 11)
(1) Affix the tab of the Clutch Bracket to the cutout of the
Bypass Clutch 3.
Figure 11 j0sa43933
02/2013
4-152
REP 39.23.1 Gate Solenoid 1 and Gate 1
Parts List on PL 39.23
Removal
WARNING
When turning OFF the power switch, check that the "Data"
lamp turns OFF. Press the <Job Status> button to check that
there are no jobs in progress/waiting in the queue. Turn OFF
the power switch and make sure that the screen display turns
OFF.
Turn OFF the main power switch, check that the "Main Power"
lamp has turned OFF, turn OFF the breaker and then unplug the
power plug.
1. [Color C75 Press]
Detach the HCS from the I/F Module. (REP 39.1.1)
[Color J75 Press]
Detach the HCS from the I/F Cooling Module. (REP 39.1.1)
2. Remove the Rear Cover. (REP 39.1.2)
3. Remove the Top Cover. (REP 39.2.1)
4. Remove the HCS Transport Motor 2. (REP 39.7.1)
5. Remove the HCS Transport Motor 1. (REP 39.5.1)
6. Disconnect the Gate Solenoid connector (x2). (Figure 1)
(1) Release the clamp (x3) and remove the wire harness.
(2) Disconnect the connector (blue).
(3) Disconnect the connector (white).
Figure 1 j0sa49941
Disassembly/Assembly and Adjustment
7. Disconnect the Bypass Clutch 1/2/3, Top Tray Clutch, Trans-
port Clutch, and Top Tray Motor connector (x6). (Figure 2)
(1) Disconnect the connector (x2).
(2) Disconnect the connector (white: x2).
(3) Disconnect the connector (blue: x2).
Figure 2 j0sa43934
8. Disconnect the connector (x3) at the bottom of the Harness
Bracket. (Figure 3)
(1) Release the clamp (x2) and remove the wire harness.
(2) Disconnect the connector (x3).
Figure 3 j0sa43940
9. Remove the Harness Bracket. (Figure 4)
(1) Remove the screw (x5).
39. HCS