Miele KWT 2662 ViS Operating And Installation Instructions page 10

Warning and Safety instructions

If the electrical connection cable supplied is damaged, it must
only be replaced by an original spare part to prevent a hazard for the
user. Miele can only guarantee the safety of the appliance when
original Miele spare parts are used.

Multi-socket adapters and extension leads do not guarantee the
required safety of the appliance (e.g. danger of overheating). Do not
use these to connect the wine conditioning unit to the mains
electricity supply.

If moisture gets into electrical components or into the mains
connection cable, it could cause a short circuit. Therefore, do not
operate this wine conditioning unit in areas which are exposed to
moisture (e.g in a garage or utility room).

This wine conditioning unit must not be installed and operated in
mobile installations (e.g. on a ship).

Damage to the wine conditioning unit can compromise your
safety. Before using the wine conditioning unit, check it for any
visible damage. Never use a damaged wine conditioning unit.

For safety reasons, this wine conditioning unit may only be used
when it has been built in.

During installation, maintenance and repair work, the wine
conditioning unit must be completely disconnected from the mains
electricity supply. It is only completely isolated from the electricity
supply when:
- the mains circuit breaker is switched off, or
- the screw-out fuse is removed (in countries where this is
applicable), or
- it is switched off at the wall socket and the plug is withdrawn from
the socket, or it is switched off at the isolator. Pull on the plug and
not the cable when disconnecting it from the power supply.
10