Installing The Ac Adapter - Makita RM350D Setup Manual

Installing the AC Adapter

Choose a well-ventilated shaded place where raindrops do not fall into. Place the AC adapter keeping 30 cm or more height from the ground. It is
recommended to fix the AC adapter on the wall using screws.
NOTICE: To prevent the connector from being deformed or damaged, connect the connector straight without tilting it.
NOTE: Household power supply for outdoor location that is not exposed to rain is required.
NOTE: If the installation location lacks sufficient load-bearing strength, reinforce it.
NOTE: After installing the AC adapter, unplug the power plug of the AC adapter.
NOTE: Do not chain the plural cabtire cables.
Fig.3
► 1. AC adapter 2. Cabtire cable
► a) 30 cm or more above the ground
Locating the charging station
The charging station charges the Robotic Mower and flows signals in the boundary wire and guide wire.
Charging station installation conditions
NOTICE: Do not bend the station base.
• Choose a possibly level place near from power source (within ±5°).
• Choose a place which is protected against direct sunlight.
• If the charging station is placed on the lawn, the area to be placed should be mowed short.
• There is a space of 3 m or more from the back end of the charging station.
(a)
(a)
(a)
(a)
Fig.4
► 1. Station base
► a) 5° or less b) 3 m or more
Determining the position of the charging station
Determine the position of the charging station by following the installation conditions.
NOTE: Do not fix the charging station. You only have to decide the position of the charging station in this step.
(a)
1
(a)
(a)
6 ENGLISH
2
1
(b)