Makita RM350D Setup Manual page 10

Robotic mower

Installing the boundary wire

NOTE: The boundary wire should be extended straight 1.5 m or more from both sides of the charging station.

NOTE: For details such as the installation distance from obstacles, refer to "Connecting the Wires to the Charging Station" (page 18).

Drive the first peg near the charging station using a plastic hammer and place the boundary wire.

Fig.5

► 1. Charging station 2. Peg

► a) 1.5 m or more

Tension the boundary wire so as not to let it float from the ground, and then drive the next peg leaving about 1 m interval from the former one.

NOTE: If the boundary wire floats, use a narrower peg interval.

NOTE: For details such as the installation distance from obstacles, refer to "Boundary wire installation conditions" (page 7)

Make a loop (eyelet) of about 20 cm to provide slack in the boundary wire at the planned boundary wire - guide wire connection site for easier

connection later.

Fig.6

► 1. Planned connection site 2. Boundary wire 3. Guide wire

NOTE: The guide wire guides the Robotic Mower when it returns to the charging station. For details on connection with the guide wire, refer to

"Installing the guide wire" (page 15).

If there are areas that the Robotic Mower should not enter or obstacles that the Robotic Mower should not encounter, exclude the area by

installing the boundary wire around there.

NOTE: For details, refer to "Making an island" (page 12).

ENGLISH

(a)

Table of Contents