Makita RM350D Setup Manual page 11

5. After installing the boundary wire up to the charging station, drive the peg near the opposite side of the peg at the starting point using a plastic
hammer.
Fig.7
► 1. Peg at starting point 2. Peg at ending point
6. Cut the wire, leaving a length of wire that can be connected to the charging station.
Fig.8
► 1. Terminal L 2. Terminal R
7. At the point where the connector can reach to the terminal, align the boundary wire with the groove of supplied connector and then bind them
firmly using pliers.
Fig.9
► 1. Boundary wire 2. Groove in the connector
2
1
2
11 ENGLISH
1
2
1