Electrical Connection - Zanussi ZOB 382 User Manual

Supply voltage (50 Hz)
Dimensions of the recess
Height under top
Height in column
Oven
Height mm 335
Width mm 405

Electrical Connection

WARNING!
Installation and connection must be done in
compliance with the regulations in force. Any
interventions must be carried out when the ap-
pliance is switched off. Only accredited engi-
neers may work on the appliance.
The manufacturer disclaims any liability if the
safety measures are not observed.
Connecting to the electrical supply
Before connecting to the electrical supply,
please make sure:
• The fuse and the domestic electrical instal-
lation must be designed for the max. load of
the appliance (see rating plate).
• The domestic electrical installation must be
equipped with a proper earth connection in
accordance with the regulations in force.
48
230 V
mm 593
mm 580
Width
Depth
Depth mm 400
Oven capacity 56 l
• The socket or the multi-pole off switch must
be easy to access after the appliance has
been installed.
This appliance is delivered with an electric sup-
ply cable.
A proper plug, according to the electric load
specified on the rating plate, must be fitted to
the cable. The plug is to be inserted into a
suitable wall socket. If you require a direct con-
nection to the electric network (mains), it will be
necessary to fit between the appliance and the
mains an omnipole switch, with a minimum gap
between contacts of 3 mm, suitable for the re-
quired load and in compliance with rules in
force. The green & yellow ground wire must not
be interrupted by the switch and it should be
2-3 cm. longer than the other cables.
The mains cable and plug as supplied are to be
connected to a shockproof socket (230 V~, 50
mm 560
mm 550