Connecting The Camera To The Recorder - Canon VC-200 Instructions Manual

Connecting the Camera to the Recorder
Camera Cable for VC-200
1
Important:
DO NOT turn on the recorder VTR
switch until all connections have been completed.
The supplied camera cable is for exclusive use
with the VC-200 camera; do not use it with other
cameras. Also, do not use any camera cable other
than that supplied with the VC-200.
With the ► mark up, push the smaller plug on the
camera cable (supplied with the camera) into the
camera connector on the front of the VC-200
camera grip until it snaps in place. (Do not hold
the cable by the sleeve while pushing it in place.)
Then attach the camera cable to the cable clamp
to hold the cable in a convenient position.
• To disconnect the cable, pull the plug while pull¬
ing back the sleeve.
Make sure the recorder's VTR switch is OFF. The
other (larger) end of the camera cable has a cut¬
out for proper alignment; for connection, it should
be facing up. Plug the cable into the recorder's
camera connector, then secure it by tightening the
outer coupling ring.
Note:
For greater mobility, the camera cable can
be lengthened 6 meters using the optional Canon
Extension Cord C-10R.
E