Table of Contents
Advertisement
6- Related Publications
Publication
Publication Number
Installation Manual AKD 10
2TSA451010P0000
Installation Manual AKD 8
2TSA451009P0000
Installation Manual AKD 6
2TSA451014P0000
Installation Manual AKD 5
2TSA451011P0000
Accessory: Door Interlock (Door Interlock Kit)
2TSA451017P0000
Accessory: Kirk Key installation Manual
2TSA451013P0000
Accessory Retrofill Direct Replacement / CiC Full Door Kits AKD-5, 6, 8 & 10
2TSA451007PO0000
Accessory Retrofill Direct Replacement / CiC Door AdaptorsKits AKD-5, 6, 8 &10
2TSA451008P0000
Accessory OEM Direct Replacement Adaptor kits AKD8 & 10
2TSE431967R1000
Accessory OEM Direct Replacement Adaptor kits, AKD8 &10, AKR 75/100, B&F TYPE
2TSE431968R1000
Accessory OEM Direct Replacement Adaptor kits, AKD8 & 10, only for AKR30S | 2TSE431996R1000
Accessory: Position Switch Plate, Assembly & Wiring
2TSA451019P0000
Accessory: Neutral CT Adapters Installation Instructions
2TSA451018P0000
Accessory: Programmer Disconnects Installation Instructions
2TSA451012P0000
Accessory: Primary Disconnects Installation Instructions
2TSA451015P0000
Accessory: Secondary Disconnects, Installation Instructions
2TSA451016P0000
E2.2, 4.2, 6.2 Breakers Installation, Operation & Maintenance Manual
1SDHOO1000RO0002
Instructions for using Ekip touch protection releases & accesories
1SDH001316RO002
Emax 2 Family Trip units Engineering manual
1SDH001330RO002
7- Service and Support
Service and support are available from ABB Inc USA.
Email: eppc.support@us.abb.com
Phone: 888-385-1221
8- Estimated Time to Complete Tasks
Wiring the secondary disconnects and verifying they match the switchgear cublicle may take
1 to 8 hrs depending on the complexity of the original breaker. Once the retrofill breaker is
fully prepared, it should take about 20 minutes to swap out the old breaker and rack in the
new Emax 2 Retrofill circuit breaker if the proper lifting bar and hoist are available, it may
take an additional 30 min to replace the door.
The Emax 2 Retrofill, when ordered with 4 wire ground fault, will be equipped with a Neutral
CT adapter.
The adapter will modify the GE MicroVersaTrip type Neutral CT output to a
Rogowski sensor output compatible with the Emax 2 Retrofill Trip Unit. With this device, it
will not be necessary to change the neutral CT in the switchgear to a Rogowski sensor.
6| © 2020 Emax 2 Retrofill Circuit Breakers 800-5000A,
2TSA451009P0000 Rev-B
Advertisement
Table of Contents
