Lowering The Front-Deck Winglets - Toro Groundsmaster 5910 Operator's Manual

2
Lowering the Front-Deck
Winglets
Parts needed for this procedure:
1 Right deck cover
1 Left deck cover
2 V-Belt
Procedure
1. Remove the nuts securing the front and rear stop bolts
to the right winglet-deck mounts
1. Winglet
2. Hinge pin
3. Stop bolt
2. While supporting the right winglet, remove the front
and rear stop bolts from the deck mounts
Note: Leave the eccentrics positioned between the
deck mounts.
3. Lower the winglet to the operating position.
4. Install the front and rear stop bolts through the
upper-mounting holes and eccentrics
Note: Ensure that the stop bolt engages the tab on
the hinge pin.
(Figure 3).
Figure 3
4. Eccentric
5. Upper hole
6. Deck mounts
(Figure
(Figure
1. Winglet
2. Hinge pin
3. Bolt
5. Install the nuts securing the stop bolts.
Note: Do not tighten the nuts at this time.
6. Repeat this procedure on left winglet.
7. Install the winglet belts as follows:
A. Start the belt around the winglet-spindle pulley
and the front-deck-spindle pulley
3).
1. Winglet-spindle pulley
2. Front-deck-spindle pulley
B. Using a ratchet wrench or a similar tool, move the
idler pulley away from the pulleys
4).
C. Route the belt around the winglet-spindle pulley
and the upper-spindle pulley on the front deck.
D. Release the idler pulley to put tension on the belt.
15
Figure 4
4. Eccentric
5. Lower hole
(Figure
Figure 5
3. Idler pulley
(Figure
5).
5).