Table of Contents
Advertisement
DUBBING (from deck A to deck B)
POWER
ON/STANDBY
POWER
ON/STANOAY
Normal dubbing
1. Turn the POWER switch ON.
2. Press the TAPE button.
3. Press PUSH OPEN ( & )ondecks A and B
to open their cassette holders.
4. Load a play tape in deck A and a recording
tape in deck B
5. Set deck B in record mode. (Press the ( > )
button while holding down the REC
/ REC
MUTE ( © ) button.)
6. Set deck A in play mode. (Press the ( D> )
button.)
High-speed dubbing
1.
Turn the POWER
switch ON.
2. Press the TAPE button.
3. Press PUSH OPEN ( ) on decks A and B
to open their cassette holders.
4. Load a play tape in deck A and a recording
tape in deck B.
5. Press the HIGH SPEED DUBBING (A >» B)
button.
To stop dubbing
Normal dubbing:
Press the ( — ) buttons on
decks A and B.
High-speed dubbing:
Pressthe(
Mf ) buttonon
deck B.
Notes:
°
Before dubbing is made, check the run-
ning direction of deck B by the TAPE RUN-
NING INDICATOR.
To change ( < ) to
( > ), while holding down(
@ ) button,
press ( D> ) button.
*®
With the Dolby system
on, tapes are
recorded in the same Dolby mode as the
prerecorded
tape had
been
recorded,
regardless of whether the DOLBY B NR
button is ON or OFF. (The DOLBY B NR
indicator
is off while
dubbing
is in
progress.)
*
Inhigh-speed dubbing, tape recording is
independent of the source selector posi-
tion, as weil as the sound volume and tone
settings, so you can listen to a source
other than TAPE
while dubbing.
(If a
source selector button other than TAPE
is pressed during normal-speed dubbing,
that source will be recorded.)
—
°
$.E.A. recording is not possible during
normal or high speed dubbing.
DR-E34BK
DR-E34LBK
REC/REC MUTE
o
Notes for dubbing:
°
As the tape length for recording may not
be enough due to differences in tapes
speed between deck A and deck B and
variations in tape length etc., use a tape
with enough length for recording.
°
Certain televisions may be affected by this
unit during high-speed dubbing. If this
happens, turn the power of the TV off or
move this unit away from the TV.
| When recording a tune (TAPE) while
monitoring it, use normal dubbing. When
listening to a source other than the tape be-
ing recorded, high-speed dubbing is con-
.
venient.
CD direct recording (deck B only)
°
By using remote cable, connect JVC CD player
or CD auto changer with the COMPU LINK ter-
minal of this equipment.
*
You can easily record a disc onto a tape syn-
chronized with it.
Basic Operations
1. Load a tape in deck B.
«To record on both sides of the tape, press
the REVERSE MODE C- button to turn its
indicator on.
2. Mount a disc on the CD player.
3. Press the CD DIRECT REC button.
Note:
¢
The source is automatically fixed at CD
during direct recording.
To switch
to
another source, press the STOP ( mm)
button on deck B or the CD piayer.
HIGH SPEED
DUBBING
Abe 8
CD DIRECT REC
J
(No. 20162)
1-13
Advertisement
Table of Contents
