Table of Contents
Advertisement
DR-E34BK
DR-E34LBK
OPERATIONS
LISTENING TO BROADCASTS
3-1.
3-2.
3-3,
3-4.
4.
To
1.
2.
3.
1-10
(No.
1
2»
POWER
ON/STANDBY
AUTO MEMORY
. Press the POWER button to turn the power
ON.
Press the FM or AM button.
Tune in a station
The TUNED
indicator will light when your
receiver has located broadcast correctly. The
STEREO indicator lights to indicate the recep-
tlon of stereo sound while tuning in an FM
broadcast.
Manual tuning
Hoid the TUNING (UP or DOWN) button
pressed to sample frequencies continuous-
ly, or press once
to seek frequencies
:n
predetermined steps. (See *2, page 9.)
Auto-tuning
Press the TUNING (UP or DOWN) button for
longer than 1 second and release, and the
receiver will start scanning and halt on recepo-
tion of a broadcast.
Preset tuning
Press the preset stations buttons to tune in
preset stations. The frequency/channe! indi-
cator will revert to the freuency display after
displaying a preset channel number jor about
2 seconds.
Preset Scan Tuning
The PRESET SCAN
button samples preset
stations each for 4 seconds.
When the desired station 's located, press the
PRESET SCAN button again while the cnan-
nel number is flashing.
Adjust the sound
volume and tone to your
taste.
preset stations
Press the FM or AM button.
Tune in a station with the TUNING
(UP or
DOWN)
button.
Press the MEMORY button making sure the
MEMORY indicator lights.
Whiie the MEMORY
indicator is on (for about
5 seconds), press the preset stations button
in which you want the station programmed.
Repeat Step 1 — 4 above.
You can program a total of up to 40 FM and
AM stations.
20162)
Note:
You cannot program stations while the
MEMORY
indicator
is off.
When
the
MEMORY
indicator
is off, press
the
MEMORY button again.
Auto memory programming
6. Select the lowest frequency of FM or AM avail-
able, or any freuency lower than the frequen-
cy you want programmed in memory.
. Press the AUTO MEMORY button.
eA channel number will flash for about 5
seconds.
. While the channel number is flashing, press a
desired preset stations button.
The
selected
station
is automatically
programmed in the preset stations button just
pressed.
*To
bypass
a station,
press
the AUTO
MEMORY
button again while the channei
number is flashing and that station will be
skipped from being programmed.
eThe
search
ends
when
auto
memory
programming is complete.
Notes:
elf a new station is programmed
in a
preset stations button in which another
has already been programmed,
it will
override the existing station preset.
¢ Station presets could be cancelled if the
power plug is disconnected from the out-
let or power is interrupted. In this case,
preset the stations again.
«When you want to stop auto memory,
press TUNING (up or down) button.
Advertisement
Table of Contents
