Viewing The Recording Oil Tv - Sony DCR-TRV6 Operating Instructions Manual

Viewing the recording on TV
Once yon connect tbe AV cordless IR receiver (not supplied) to yonr TV or VCR, you
can easily view the picture on your TV. For details, refer to tile operating instructions of
tile AV cordless IR receiver.
SUPER LASER LINK
Super laser link emitter --
Insert a tape into yore camcorder.
(1) After connecting your TV and AV cordless IR receiver, set tile POWER switch
oi1 the AV cordless IR receiver to ON.
(2) Set the POWER switch to VCR.
(3) Turn the TV oi1 and set the TV/VCR selector oi1 the TV to VCR.
(4) Press SUPER LASER LINK. The lamp of SUPER LASER LINK lights up.
(5) Press _ on your camcorder to start playback.
(6) Point the super laser link emitter at the AV cordless IR receiver. Adjust the
position of your camcorder and the AV cordless IR receiver to obtain cleat"
playback pictures.
-u
g
I
To cancel the super laser link function
Press SUPER LASER LINK again. Tbe lamp on tile SUPER LASER LINK button goes
ont.
If you turn the power off
Tile snper laser link ftmction tnrns off atttomatically.
If you use a Sony TV
• Yon can tnrn on the TV atttomatically
wben yon press SUPER LASER LINK. To do so,
make sure yon:
Tnrn the TV's main switch on.
Set AUTO TV ON to ON in tile menu settings.
Point tbe snper laser link emitter at tile TV's remote sensor.
• You can switch the video input of the TV atttomatically to tile one which the AV
cordless IR receiver is connected. To do so, set AUTO TV ON to ON and TV INPUT to
the same video input (1, 2, 3) in tile menn settings. With some models, however, tile
picture and sound may be disconnected momentarily when tile video input is switched.
• Tile above %ature may *lot work on some TV models.
When the super laser link is activated (the SUPER LASER LINK button is lit)
Your camcorder consnmes power.
Press SUPER LASER LINK to ttnn off tile laser link
f\mction when it is not needed.
,_ is a trademark of Sony Corporation.
29