Recording A Picture - Sony DCR-TRV6 Operating Instructions Manual

Recording a picture
Note on the LOCK switch (DCR-TRV11/TRV20 only)
When you slide the LOCK switch to tile right, the POWER switch can no longer be set
to MEMORY accidentally. LOCK switch is set to tile left before your comcorder leaves
the fhctol T.
To enable smooth transition _
Transition between the last scene you recorded and the next scene is smooth as long as _u
you do not eject the cassette even if you tnrn off your camcorder.
However, check tile %llowing: K
• Do not mix recordings in tbe SP mode and ones in the LP mode on one tape. _aS'
•When you change tile batte W pack, set tile POWER switch to OFF (CHG).
m
When yon use a tape with cassette memo1 T, however, yon can make tile transition g
smooth even after ejecting the cassette if you use the END SEARCH hmction (p. 24). 5'
If you leave your camcorder in the standby mode for five minutes while the
cassette is inserted
Yore cameorder auton-latically turns off. This is to save battery power and to prevent
batte W and tape wear. To resume the standby mode, set the POWER switch to OFF
(CHG), and to CAMERA again.
When you record in the SP and LP modes on one tape or you record some scenes
in the LP mode
Tbe playback picture may be distorted or the time code may not be written properly
between scenes.
The LCD panel moves about 90 degrees to tile viewfinder side and about 180 degrees to
the lens side.
If you turn tbe LCD panel over so that it faces tbe other way, tile @ indicator appears
on tile LCD screen and in the viewfinder (Mirror mode).
When closing tile LCD panel, set it vertically tmtil it clicks, and swing it into tile
camcorder body.
Note
When using tile LCD screen except in the nlirror nlode, the viewfinder autonlatieally
turns off.
17