Table of Contents
Advertisement
out, because the rope may break or the recoil
assembly may be damaged.
6. When the engine has started, push the choke lever to
the off position.
7. Move the throttle lever to the desired setting (usually
Fast).
Stopping the Engine
1. Turn the engine speed to idle, and allow it to run for 10
to 20 seconds.
2. Turn the On/Off switch to the off position.
3. Turn the fuel-shutoff valve to the closed position.
Transporting the Machine
1. Drive the machine to the transport vehicle.
2. Move the throttle lever to the low-speed position, and
allow the engine to run for 10 to 20 seconds.
3. Turn the On/Off switch to the Off position.
4. Turn the fuel-shutoff valve to the Closed position.
5. To raise the machine onto its transport wheels:
A. Remove the lynch pin securing the lifting bar to
the tab on the tow bar bracket and remove the bar
the from the bracket (Figure 8).
1. Lifting bar
2. Tow bar
1
g018663
Figure 8
3. Lynch pin
B. Slide the bar onto the tab on the left hand side of
3
1. Lifting arm tab
2. Lifting bar
C. While holding the lifting bar, release the latch and
D. Using the lifting bar, raise the unit onto the
6. To lower the machine onto the rollers:
A. While holding the lifting bar, release the latch and
B. Push the lifting bar down until the lifting arm
2
C. Remove the lynch pin securing the lifting bar to
D. Remove the lifting bar the from the lifting arm
3
E. Secure it to the tab on the tow bar bracket with
Operating the Machine
1. Sit on the operator seat, taking care not to contact the
motion pedals as you sit down.
2. Adjust the seat and steering wheel to a comfortable
operating position.
13
the lifting arm assembly and secure it with a lynch
pin (Figure 9).
2
Figure 9
3. Latch
start lifting the wheels with the lifting bar.
Note: The lifting arm assembly has a gas ram
which assists in lifting the roller. Once you have
moved the transport wheels so that they are
touching the ground, you will have to push harder
to get them over center and then they will lock
into place.
transport wheels and ensure they are locked in
place.
let the machine lower gently to the turf.
assembly locks into the raised position.
the lifting arm assembly.
assembly and install it onto the tab on the tow
bar bracket.
the lynch pin.
1
g018664
Advertisement
Table of Contents
