Related Manuals for Toro 44401
Summary of Contents for Toro 44401
- Page 1 Form No. 3433-937 Rev C Sulky Mid-Size Mowers Model No. 44401—Serial No. 400000000 and Up *3433-937* C Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Table Of Contents
Maintenance ............. 8 additional information, contact an Authorized Service Greasing the Sulky ..........8 Dealer or Toro Customer Service and have the model and serial numbers of your product ready. Figure 1 identifies the location of the model and serial numbers on the product. -
Page 3: Safety
Safety • Ensure that you operate the sulky in areas where there are no obstacles nearby. Failure to maintain adequate distance from trees, walls, and other • Ensure that the sulky is properly attached to the barriers may result in injury as the sulky backs machine and is in good working order prior to use. -
Page 4: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal140-1917 140-1917 1. Crushing hazard of legs—read the Operator’s Manual; do not turn more than 90°;... -
Page 5: Setup
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. Mount plate Bolt Pivot pin Install the sulky. Hairpin cotter Transport pin Sulky Important: A Weight Kit is required for 91 cm (36 inch) machines and is optional for other sizes. Contact your Authorized Service Dealer to obtain the kit, and install it before installing the sulky. - Page 6 g295053 Figure 4 g315914 Figure 2 Store the transport pin in the pin plate shown Figure Important: Do not store the transport pin Attach the sulky to the bracket using the pivot in the drawbar tube while operating the pin and hairpin cotter (Figure machine.
-
Page 7: Operation
Operation WARNING You could fall off the platform and be seriously injured during operation. Do not move the machine forward unless you are standing with both feet on the platform and your hands are holding onto the reference bars. Step off the platform when moving the machine in reverse. -
Page 8: Maintenance
Maintenance Greasing the Sulky Service Interval: Before each use or daily—Inspect the grease fittings. Every 40 hours—Grease the platform (grease immediately after each washing). Grease type: General-purpose grease Park the machine on a level surface, disengage the PTO, and engage the parking brake. Shut off the engine and remove the key. - Page 9 Notes:...
- Page 10 Notes:...
- Page 11 The Toro Company (“Toro”) respects your privacy. When you purchase our products, we may collect certain personal information about you, either directly from you or through your local Toro company or dealer. Toro uses this information to fulfil contractual obligations - such as to register your warranty, process your warranty claim or to contact you in the event of a product recall - and for legitimate business purposes - such as to gauge customer satisfaction, improve our products or provide you with product information which may be of interest.
- Page 12 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.