Table of Contents
Advertisement
Engine Controls
On/Off Switch
The On/Off switch (Figure 5) allows the operator of the
machine to start and stop the engine. This switch is located
on the front of the engine. Rotate the On/Off switch to the
On position to start and run the engine. Rotate the On/Off
switch to the Off position to stop the engine.
OFF
1
1. Off position
Choke Lever
The choke lever (Figure 6) is required when starting a cold
engine. Before pulling the recoil-start handle, move the choke
lever to the closed position. Once the engine is running,
move the choke lever to the open position. Do not use
the choke if the engine is already warmed up or if the air
temperature is high.
1
2
1. Choke lever
2. Fuel-shutoff valve
OFF
2
Figure 5
2. On position
3
G019815
Figure 6
3. Throttle lever
Throttle Lever
The throttle lever (Figure 6) controls the speed (rpm) of the
engine. It is located next to the choke control. It sets the
engine rpm and therefore can increase and decrease the speed
of the machine. For best performance, set this control to
the fast position.
Fuel-shutoff Valve
The fuel-shutoff valve (Figure 6) is located underneath the
choke lever. Move it to the open position before attempting
to start the engine. Once you have finished using the machine
and you have turned the engine off, move the fuel-shutoff
valve to the closed position.
Recoil-start Handle
To start the engine, pull the recoil-start handle (Figure 4)
quickly to turn the engine over. The controls on the engine
G021 103
described above must all be set correctly for the engine to
start.
Oil-level Switch
The oil-level switch is located inside the engine; it prevents
the engine from running if the oil level falls below the safe
operating limit.
Specifications
Weight
Length
Width
Height
Maximum Speed
10
240 kg (529 lb)
136 cm (53.5 inches)
122 cm (48.0 inches)
107 cm (42.2 inches)
10 km/h (6.2 mph) @ 3200 rpm
Advertisement
Table of Contents
