Installing Material Stop Bracket; Adjusting Wire Brush - Sharp SW-130HT Instruction Manual

INSTALLING MATERIAL STOP BRACKET

This device is easy to cut the same length repeatedly and saves adjusting time.
Step 1 - Install the depth bar and tighten the set
screw. The depth bar is taken off from the
machine base during transit for safety reason.
Step 2 - Lift the saw bow and clamp material
securely with vise.
Step 3 - Lower the saw bow to allow about 1 mm
clearance between saw blade teeth edge and the
top of the material. Then measure your desired
cutoff length.
Step 4 - Loosen the fastening bolt.
Step 5 - Slide and position the stopper so that the
end of stopper faces the direction of the front
end of the material. Then tighten the stopper
handle to fix the stopper in the bracket.
Step 6 - Move the stopper bracket toward the
workpiece so the stopper end just touches the
front of the material, then tighten the fastening
bolt.

ADJUSTING WIRE BRUSH

Follow these steps to adjust wire brush to appropriate position:
Step 1 – Open the drive wheel cover. Loosen the adjustment bolt.
Step 2 – Adjust brush to make it move up / down until it makes proper contact with the saw blade
(see below illustration).
Step 3 – Tighten the adjustment bolt. Close the drive wheel cover.
Proper Improper
4-12