Table of Contents
Advertisement
REMOVING SHIPPING BRACKET
After the machine has been properly
positioned, remove the shipping bracket
that is used to lock the saw frame and
the saw bed.
Retain this bracket so that it can be
used again in the event that your
machine must be relocated.
CLEANING
After the machine has been placed at the designated position, remove the rust-preventive grease
with wiping cloth dampened with cleaning oil or kerosene. Apply machine oil to machine surfaces
that are prone to rust.
Do not remove the rust-preventive grease with a metal scraper and do not wipe the
painted surfaces with solvent as doing so would damage surface paint.
INSTALLING
Our bandsaw machine is relatively easy to install. Follow these six easy steps to install your machine.
Supply
hydraulic oil
Supplying hydraulic oil
Open the filler cap and fill the hydraulic oil tank to
above 2/3 or full level.
Check the sight gauge to make sure the oil level in the
tank.
Refer to specification chart under Section 2
for tank capacity.
Oil tank should be full already if it is a new
machine that operates for the first time.
Supply
cutting fluid
Connect
Leveling &
electric
anchoring
power
Installing roller
table
(Optional)
3-7
Advertisement
Table of Contents
