Table of Contents
Advertisement
TA B L E O F C O N T E N T S
Note: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between
the equipment and receiver
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected
• Consult the dealer or an experienced
radio/TV technician for help
Industry Canada compliance statement
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions:
• This device may not cause interference
• This device must accept any interference, including
interference that may cause undesired operation
of the device
≔
P R E V I O U S C H A P T E R
←
→
N E X T C H A P T E R
RF exposure statement
This equipment complies with IC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance
20cm between the radiator and your body.
General safety instructions
• This document, the related documents and the warnings
included do not replace your responsibility to use your
common sense when you do work on the EVSE
• Only do the procedures that the related documents
show and that you are qualified for
• Obey the local rules and the instructions in this manual.
If the local rules contradict the instructions in this manual,
the local rules will apply
If and to the extent permitted by law, in case of
inconsistency or contradiction, between any requirements
or procedure contained in this document and any such local
rules, obey the stricter between the requirements and
procedures specified in this document and the local rules.
—
Table 6: Signs on the EVSE
Symbol
Risk type
General risk
Hazardous voltage that gives risk of electrocution
Risk of pinching or crushing of body parts
Rotating parts cat can cause a risk of entrapment
PE
Sign that means that you must read the manual
before you install the EVSE
Waste from electrical and electronic equipment
7
Advertisement
Table of Contents
