Mitsubishi Electric 800 Series Instruction Manual page 24

NOTE
• The parameter names for function assignment to the terminals listed below or the terminal names for I/O terminal monitor
(Pr.52) are the standard control circuit terminal names of the inverter.
FR-A8TP terminal
name
DI1 180
DI2 181
DI3 182
DI4 185
OH ―
DO1 190
DO2 191
DO3 192
ABC 195
For the details of the parameter setting or the I/O terminal monitor, refer to the Instruction Manual (Detailed) of the inverter.
• Same terminal has same specification between the terminal or the FR-A8TP and the standard control circuit terminal of the
inverter.
Use Pr.178, Pr.179, Pr.189, or Pr.158 to change the function of terminal STF, STR, RES, or AM respectively, same as the
standard control circuit terminal of the inverter.
• Even when the FR-A8TP is installed in the inverter, the following standard control circuit I/O terminals of the inverter can be
used only via communication (the RS-485 communication or other communication options) as if the standard control circuit
is installed in the inverter.
Terminal name
Input terminal RT, AU, STP, CS
Output terminal OL, FU, ABC2
Pr.
RL terminal function selection
RM terminal function selection
RH terminal function selection
JOG terminal function selection
―
RUN terminal function selection
SU terminal function selection
IPF terminal function selection
ABC1 terminal function selection
Terminal symbol
I/O terminal monitor
RL
RM
RH
JOG
AU
RUN
SU
IPF
ABC1
PRE-OPERATION INSTRUCTIONS
1
23