Advancing The Line Manually - Toro Flex-Force Power System 60V MAX Manual

Advancing the Line Using
the Bump Feed
1. Run the trimmer at full throttle.
2. Tap the bump button on the ground to advance
the line. The line advances each time the bump
button is tapped. Do not hold the bump button
on the ground.
Note:
The line trimming cut-off blade on the
grass deflector cuts the line to the correct length.
Note:
If the line is worn too short, you may not
be able to advance the line by tapping it on the
ground. If so, release the trigger and refer to
Advancing the Line Manually (page
Figure 13
1. Bump button
Advancing the Line
Manually
Remove the battery pack from the trimmer, then push
the bump button at the base of the spool retainer
while pulling on the trimmer line to manually advance
the line.
16).
g331007
16