Chapter 4 Appendix; Specifications - NEC EXP804 User Manual

Chapter 4 Appendix

1.

Specifications

Part Number
On-board CPU, operation
frequency
Number of cores
threads (T) (1CPU)
CPU Intel Smart Cache (Last
level cache)
Number of
installation/ maximum
installation
Chipset
On-board
standard/ maximum
On-board Memory
Maximum
frequency
Memory
Error Detection
Correction
Memory sparing
Memory mirroring
Built
-in
slot
Built-in
standard
Drive
bay
Secondary
memory
Maximum
device
built-in
Hot-swap
Interface specification and
RAID configuration
Optical disk drive
FDD
Expansion bay
Expansion Corresponding Slots
Built-in chips/ video RAM
Graphics
Graphics and resolution
Front
Standard interface
Rear
Internal parts
Redundant power supplies
Redundant fans
Dimensions (Width x depth x height)
Mass (Minimum*3 / maximum)
212
N8100-2557F
(C)/
standard
capacity Not included in Standard Installation/ (Option)
Registered DIMM: 768GB (24x 32GB), Load Reduced DIMM: 3.0TB (24x 128GB)
DDR4-2666 Registered DIMM (8/16/32GB), DDR4-2666 Load Reduced DIMM (64/128GB)
operation
2666MHz (See System Configuration Guide regarding the maximum operation frequency of each CPU)
and
8x2.5 inch drive
Front 2x2.5 inch additional
(maximum one)
Rear
Interna
l parts
2.5 inch HDD: SATA 22TB (11x
2TB),
SAS 19.8TB (11x 1.8TB)
2.5 inch SSD: SATA 42.24TB
(11x 3.84TB),
SAS 10.56TB (11x 960GB)
2.5 inch PCIe SSD: PCIe 3.2TB
(2x 1.6TB)
(When an optional HDD cage
is added)
SATA 6Gb/s : RAID 0/1/5/6/10/50/60 (Option),
SAS 12Gb/s : RAID 0/1/5/6/10/50/60 (Option)
Standard configuration
1x PCI Express 3.0 (x16 lanes, x16 sockets) (full-height, 3/4 length/slot1)
1x PCI Express 3.0 (x8 lanes, x8 sockets) (low profile, half-length/ slot2)
1x PCI Express 3.0 (x8 lanes, x8 sockets) (exclusive use for RAID controller)
1x PCI Express 3.0 (x8 lanes, x8 sockets) (exclusive use for LOM card)
(You can change PCI configuration by preparing optional raiser cards. See the system configuration guide
for the detailed information. )
1677 million colors: 640x480, 800x600, 1,024x768, 1,280x1,024, 1,600x1,200, 1,920x1,200
Standard specification
1x USB3.0(Type A), 1x USB2.0(Type A) (for iLO)
Options
1x USB3.0 (Type A), 1x Status LED Panel
(Systems Insight Display)
2x USB3.0 (TypeA), 1x Analog RGB (Mini D-Sub pin),
1x Management Dedicated LAN Connector (Compatible with 1000BASE-T/100BASE-TX/10BASE-T,
RJ-45)
4x Data LAN Connector (Compatible with 1000BASE-T/100BASE-TX/10BASE-T (RJ-45))
1x Serial Port (Option)
2x USB3.0 (TypeA), 2x (4x SATA2.0 Port), 1x (2x SATA2.0 Port)
Capable (Optional, hot plug-able)
Capable (Standard specification, hot plug-able)
434.6mm × 707.0mm × 42.9mm (Front bezel/ rails
/protuberances not included)
14kg /26kg
Express5800/R120h-1M User's Guide
N8100-2558F
See the attached file "On-board CPU"
0/2
Intel® C621 Chipset
ECC, x4 SDDC
Capable
Capable
drive 10 x 2.5 inch drive
1x 2.5 inch drive (maximum one)
2x M.2 SATA slots
－
2.5 inch HDD: SATA 18TB
(9x 2TB),
SAS 16.2TB (9x 1.8TB)
2.5 inch SSD: SATA 34.56TB
(9x 3.84TB),
SAS 8.64TB (9x 960GB)
2.5 inch PCIe SSD: PCIe 16TB
(10x 1.6TB)
(When optional HDD cage is
added)
Capable
Connection of built-in/ external drive (Option) *1
Option: flash FDD(1.44MB) *2
-
Internal management controller chip/ 16MB
Standard specification
1x USB3.0(Type A), 1x USB2.0(Type A) (for iLO)
Options
1x USB3.0 (Type A), 1x Status LED Panel (Systems
Insight Display),
1xDisplayport,1xUSB2.0(Type A)
434.6mm × 749.8mm × 42.9mm (Front bezel/ rails/
protuberances not included)
14kg/29kg
1. Specifications
N8100-2561F
4x3.5 inch drive
3.5 inch HDD : SATA 40TB(4x
10TB)
2.5 inch HDD : SATA 2TB(1x
2TB), SAS 1.8TB(1x 1.8TB)
2.5 inch SSD : SATA 3.84TB
(1x3.84TB)
SAS 960GB (1x960GB)
(When an optional HDD cage is
added)