Table of Contents
Advertisement
Chapter 2 Preparations
6.
If you like to secure the unit to the rack with screw, open the lid of the edge part of the unit and fasten
the screw inside with a hexalobular driver to secure the unit to the rack.
2) Removal procedure
Remove the server from the rack in the following procedure.
1.
Make sure that the server is turned off and then disconnect the power cord or all interface cables from
the server.
2.
Remove the front bezel.
3.
Open the lids of the unit fixing screws on both sides of the device. Then remove the fixing screws
inside with hexalobular driver, if the device is screwed on. If the device is not screwed on, you can
unlock the device just by opening the lid.
178
Important
At least two persons are required to remove the server from rack.
Express5800/R120h-1M User's Guide
2. Installation and Connection
Advertisement
Table of Contents
